Стекло турбины

Getting started — your first turbine Build a closed turbine shell with a rotor and coils inside, then pick one of the two setups below. Rotate the scene to inspect each face. Shell layout Floor and roof: Turbine Casing (closed frame). Vertical corners: Turbine Casing pillars at the four edges (y=1…5). West, east, and south walls: 5×5 Turbine Glass panel on each face. Divider wall at rod-controller height (y=3 in the example): Turbine Casing ring inside and casing band on the side walls — this row cuts through the 5×5 glass on those three faces. Controller face (north in the example): the Turbine Controller protrudes outward as a single block; remaining cells on that face use Turbine Glass where no port is placed. Ports replace glass on that wall — same layout as the reactor example. Coil zone (above the divider): two layers at the top of the interior (y=4–5 in the example) — copper blocks directly under the roof casing. Rotor zone (below the divider): two rod segments (y=1–2) — four blades on the lower ring, eight blades in two rings on the upper segment; Turbine Rod Controller sits …

Turbine structure Building the shell Use Turbine Casing for solid walls and Turbine Glass where you want to see inside. Build a closed box. Default maximum size is 65×65×65 (same idea as large reactors; your pack may allow less). Inside you need space for rods and blades, a coil section, ports on the walls, and one Turbine Controller on an outer side wall (north, south, east, or west—not the top or bottom of the box). Rod controllers Place Turbine Rod Controller blocks on the closure deck—the casing layer that separates the rotor (below) from the coil zone (above). They set which way the shaft runs (you can orient them in six directions, like a heating coil). You need at least one. You may place one controller per rod column, each sitting directly on the deck cell above that column’s rod pile. All controllers must share the same deck plane and the same facing. Controllers are not on the outer shell border. If any rod column has rods but no controller on its deck cell, blade efficiency takes a −5% penalty (see Rods and blades). Putting a controller on every rod column cancels that pen…